מצב איזון קרקע של שיטת זיהוי מתכות

Ground balance mode of Metal detection method This method can eliminate the influence of earth 

"mineralization reaction", and has better penetrability: therefore, whether indoor or outdoor work, have preferred this way: When detected underground metal objected exist, push mode switch to "recognition" mode to identify the type of metal. When the exploration of the underground metal object exist, species and identification of the documents to identify metal. In the ground balance mode, as long as the sensor coil is moved to the top of the target metal, the instrument will make a continuous sound, any type of metal will make the sound increase, the instrument detection indicator will gradually increasing.

הליך הפעולה הוא כדלקמן:

1) Operation mode switch to "Ground balance" mode.

2) הרם את הגשושית 70-80 ס"מ מהקרקע.

3) The power switch is turn on, press the middle button and release, clockwise the power switch 

knob until the "critical sound" appear.

4) Let the sensor coil close to the ground, 10-15cm from the ground, if "critical sound" increases, lift 

the probe, to press the reset button and then released, turn the adjustment knob counter clockwise, turn left a little bit, and then close to the ground and try again, if the sound increased again, 

repeat the above procedure again and turn left little bit , after several adjustments, until the probe 

to lift up and down the "critical sound" without change, the balance was fine. Instrument after this 

adjustment, the earth's "mineralization reaction" basically excluded, probe moving freely on the 

ground will not change the "critical sound" signal. Until detect metallic target.

5) אם הגשושית קרובה לקרקע בצליל נמוך יותר, הרם את הגשושית, לחץ על לחצן האיפוס ושחרר, ואז סובב את כפתור הכוונון עם כיוון השעון (סובב לצד ימין), ולאחר מכן קרוב לקרקע ונסה, אם הצליל עדיין קטן , ולאחר מכן כוונן שוב, עד שההרמה מעלה והורדת הגשושית נשמעת זהה.

6) הערה: לפני כל אחת מההתאמות לעיל, לחץ על הלחצן ושחרר.

7) According to the above adjustment, we can slowly moving the probe along the ground, in the process of detection the instrument should always keep the "buzzing" critical sound, if sound slowly increases or decreases, can press the reset button to make the "critical" sound returned to normal. If a metal is detecting, the instrument sound will issue a big sound, the sensitivity detection will light up 

עולה בהדרגה.